ZyXEL Communications P-793H v3 User Manual page 213

Table 91 Packet Filter Logs
LOG MESSAGE
[ TCP | UDP | ICMP | IGMP |
Generic ] packet filter
matched (set: %d, rule: %d)
For type and code details, see
Table 92 ICMP Logs
LOG MESSAGE
Firewall default policy: ICMP
<Packet Direction>, <type:%d>,
<code:%d>
Firewall rule [NOT] match: ICMP
<Packet Direction>, <rule:%d>,
<type:%d>, <code:%d>
Packet without a NAT table entry
blocked: ICMP
Unsupported/out-of-order ICMP:
ICMP
Router reply ICMP packet: ICMP
Table 93 CDR Logs
LOG MESSAGE
board %d line %d channel %d,
call %d, %s C01 Outgoing Call
dev=%x ch=%x %s
board %d line %d channel %d,
call %d, %s C02 OutCall
Connected %d %s
board %d line %d channel %d,
call %d, %s C02 Call
Terminated
Table 94 PPP Logs
LOG MESSAGE DESCRIPTION
The PPP connection's Link Control Protocol stage has started.
ppp:LCP Starting
The PPP connection's Link Control Protocol stage is opening.
ppp:LCP Opening
The PPP connection's Challenge Handshake Authentication Protocol stage is
ppp:CHAP Opening
opening.
The PPP connection's Internet Protocol Control Protocol stage is starting.
ppp:IPCP
Starting
Chapter 22 Logs
DESCRIPTION
Attempted access matched a configured filter rule (denoted
by its set and rule number) and was blocked or forwarded
according to the rule.
Table 100 on page 216.
DESCRIPTION
ICMP access matched the default policy and was
blocked or forwarded according to the user's setting.
ICMP access matched (or didn't match) a firewall rule
(denoted by its number) and was blocked or forwarded
according to the rule.
The router blocked a packet that didn't have a
corresponding NAT table entry.
The firewall does not support this kind of ICMP packets
or the ICMP packets are out of order.
The router sent an ICMP reply packet to the sender.
DESCRIPTION
The router received the setup requirements for a call. "call"
is the reference (count) number of the call. "dev" is the
device type (3 is for dial-up, 6 is for PPPoE, 10 is for PPTP).
"channel" or "ch" is the call channel ID.For example,"board 0
line 0 channel 0, call 3, C01 Outgoing Call dev=6 ch=0
"Means the router has dialed to the PPPoE server 3 times.
The PPPoE, PPTP or dial-up call is connected.
The PPPoE, PPTP or dial-up call was disconnected.
P-79X Series User's Guide
213