ZyXEL Communications P-793H v3 User Manual page 23

Chapter 2 Introducing the Web Configurator
Table 6 Navigation Panel Summary
LINK TAB
Address
Mapping
ALG
Security
Firewall General
Rules
Threshold
URL Blocking Keyword
Schedule
Trusted
Packet Filter Packet Filter
VPN Setup
Monitor
Certificates Trusted CAs
Advanced
Static Route Static Route
802.1Q Group Setting
Port Setting
QoS General
Class Setup
Dynamic Dynamic DNS
DNS
FUNCTION
Use this screen to configure network address translation
mapping rules.
This screen appears when you choose Full Feature from the
NAT > General screen.
Use this screen to enable or disable SIP ALG.
Use this screen to activate/deactivate the firewall and the
default action to take on network traffic going in specific
directions.
This screen shows a summary of the firewall rules, and allows
you to edit/add a firewall rule.
Use this screen to configure the thresholds for determining
when to drop sessions that do not become fully established.
Use this screen to block access to web sites containing certain
keywords in the URL.
Use this screen to set the days and times for the P-79X to
perform content filtering.
Use this screen to exclude a range of users on the LAN from
content filtering on your P-79X.
Use this screen to configure the rules for protocol and generic
filter sets.
Use this screen to configure each VPN tunnel.
Use this screen to look at the current status of each VPN
tunnel.
Use this screen to import CA certificates to the P-79X.
Use this screen to configure IP static routes to tell your P-79X
about networks beyond the directly connected remote nodes.
Use this screen to activate 802.1Q, specify the management
VLAN group, display the VLAN groups and configure the
settings for each VLAN group.
Use this screen to configure the PVID.
Use this screen to enable QoS and traffic prioritizing, and
configure bandwidth management on the WAN.
Use this screen to define a classifier.
This screen allows you to use a static hostname alias for a
dynamic IP address.
P-79X Series User's Guide
23