ZyXEL Communications P-793H v3 User Manual page 220

Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE your device. When the Restore Configuration process is
complete, the device automatically restarts.
Restore Using FTP Session Example
Figure 125 Restore Using FTP Session Example
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Refer to Section 23.1.2 on page 218
WAN.
FTP and TFTP Firmware and Configuration File Uploads
These examples show you how to upload firmware and configuration files.
Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE your device.
FTP is the preferred method for uploading the firmware and configuration. To use this feature, your
computer must have an FTP client. The following sections give examples of how to upload the
firmware and the configuration files.
FTP File Upload Command from the DOS Prompt Example
Launch the FTP client on your computer.
1
Enter "open", followed by a space and the IP address of your device.
2
Press [ENTER] when prompted for a username.
3
Enter your password as requested (the default is "1234").
4
Enter "bin" to set transfer mode to binary.
5
Use "put" to transfer files from the computer to the device, for example, "put firmware.bin ras"
6
transfers the firmware on your computer (firmware.bin) to the device and renames it "ras".
Similarly, "put config.rom rom-0" transfers the configuration file on your computer (config.rom) to
the device and renames it "rom-0". Likewise "get rom-0 config.rom" transfers the configuration file
on the device to your computer and renames it "config.rom." See earlier in this chapter for more
information on filename conventions.
Enter "quit" to exit the ftp prompt.
7
Chapter 23 Tools
to read about configurations that disallow TFTP and FTP over
P-79X Series User's Guide
220