Changing The Logo On The Home Screen - Fluke OF-500-10 Technical Reference Handbook

OF-500 OptiFiber Certifying OTDR
Technical Reference Handbook

Changing the Logo on the HOME Screen

The tester's HOME screen shows the Fluke Networks logo
by default.
To change the logo on the HOME screen:
1 Register your tester with Fluke Networks to receive a
registration key. See "Registration" on page 1-2 for
details.
2 Use a graphics application to create a graphic with
the following format:
•
Dimensions: 240 x 60 pixels maximum.
•
Colors: 128 colors maximum, with an indexed color
palette.
•
File format: Save the graphic as an 8-bit bitmap file
(.bmp) or an 8-bit Portable Networks Graphic file
(.png).
The graphics application may list 256 colors with
the 8-bit setting; however, if your graphic uses
only 128 or fewer colors, it should work in the
tester.
1-26
Note
F
3 Press ; then select Enable OptiFiber Options.
4 On the OPTIFIBER OPTIONS screen, highlight
CUSTOM LOGO; then press
5 Enter the software key in the CUSTOM LOGO key
s
box; then press .
6 Connect the tester to the PC via the serial or USB
port.
7 In LinkWare select Utilities > OptiFiber Utilities >
Custom Logo. Locate and select the .bmp or .png
logo file; then click Open.
8 Restart the tester to see the new logo.
If the logo's format is not valid, the tester deletes
the logo and uses the default logo.
To restore the Fluke Networks logo, select Utilities >
OptiFiber Utilities > Restore Default Logo; then restart the
tester
t
.
Note