OF-500 OptiFiber Certifying OTDR
Technical Reference Handbook
Verifying Operation
When you install the loss/length module in the tester, the
module's model number should show in the upper-right
corner of the screen. If the screen shows No Module
Installed, refer to "If Something Seems Wrong" in
Chapter 10.
SETUP Tab
Setting
Job tab
Job settings
Cable tab
FIBER TYPE
6-6
Table 6-1. Loss/Length Test Settings
The job settings are saved with test results to identify the job site, the cables tested,
and the test direction. Before you run a test you will save, verify that the job and
fiber ID information is correct. See Chapter 2 for details.
Select a fiber type that is appropriate for the type you will test. You can select
factory-installed fiber types or custom types, which you configure with the Edit
Custom Test Limit function in FUNCTIONS. See Chapter 9 for information on creating
custom fiber types.
Loss/Length Test Settings
Table 6-1 summarizes the loss/length test settings. To
access these settings, press
Description
S
.