Changing The Language; Removing And Installing The Module; Verifying Operation - Fluke OF-500-10 Technical Reference Handbook

OF-500 OptiFiber Certifying OTDR
Technical Reference Handbook

Changing the Language

To change the tester's language, do the following:
S
1 Press .
N
2 Press once to select the System tab.
L
3 Press to select LANGUAGE; then press
ML
4 Use to select the desired language; then press
t
.
5 Restart the tester to apply the new language.
Additional languages for the tester may be available with
software updates available on the Fluke Networks
website. Use LinkWare software to install or remove
languages. See "Updating the Tester's Software" in
Chapter 11 for details.
1-10

Removing and Installing the Module

The tester's capabilities depend on which test module is
installed. Figure 1-2 shows how to remove the module.
To avoid corrupting the tester's software,
t
.
always turn the tester off before removing or
installing the module.

Verifying Operation

The tester performs a basic self-test when you turn it on. If
the tester reports an error or does not turn on, refer to "If
Something Seems Wrong" in Chapter 11.
The tester shows the model number of the installed
module in the upper-right corner of the screen. If the
screen shows No Module Installed or Problem with
Module or The module needs a software update refer to
"If Something Seems Wrong" in Chapter 11.
W
Caution