OF-500 OptiFiber Certifying OTDR
Technical Reference Handbook
Selecting a Custom Limit
To select a custom limit to use for testing, do the
following:
1
Verify that the fiber type selected on the Cable tab in
Setup is used in the test limit you want to select. The
test limit will not appear if it does not support the
selected fiber type.
S
2
Press
, select TEST LIMIT on a test's tab; then
select the limit from the list. Custom test limits are
marked with asterisks (*).
10-8
To delete a custom limit, do the following:
F
1
Press
; then select Edit Custom Test Limit.
2
Select the limit; then press
If the Limit or Fiber Type is Not Valid
If the tester says that the limit or fiber type is not valid
when you try to run a test, you may need to add more
parameters to the configuration. For details, see "If the
Test Limit or Fiber Type is Not Valid with the Test" in
H
Chapter 2 or press
when the message appears.
B
Delete Limit.