Message Waiting Indicator Line - Aastra 6730i Administrator's Manual

Operational Features
Configurable Status Code on Ignoring Incoming Calls
When a user presses the "Ignore" key on the phones during an incoming call, the phone rejects the incoming call with a
status code of "486 Busy Here". The IP phones allow an administrator to configure this status code. You can configure the
status code using the configuration files only.
Note:
Valid status codes are based on RFC3261.
Use the following parameter to configure a status code when ignoring incoming calls:
• sip ignore status code
Configuring Status Codes on Ignoring Incoming Calls
You can use the following procedure to set the status code sent in the response when a user presses the "Ignore" key.
Configuration Files
For the specific parameter you can set in the configuration files, see Appendix A, the section,

Message Waiting Indicator Line

A User or Administrator can configure the Message Waiting Indicator (MWI) to illuminate for a specific line or for all lines.
For example, if you configure the MWI LED on line 3 only, the LED illuminates if a voicemail is pending on line 3. If you
configure the MWI LED for all lines, the LED illuminates if a voicemail is pending on any line on the phone (lines 1
through 9).
A User can configure the MWI using the Aastra Web UI only. An Administrator can configure the MWI on single or all lines
using the configuration files or the Aastra Web UI.
Configuring Message Waiting Indicator (MWI)
Use the following procedures to configure MWI on the IP phone.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
5-73
"Status Code on Ignoring Incoming Calls"
"Message Waiting Indicator Settings"
41-001343-02 REV05 – 07.2014
on page A-122.
on page A-127.