No Service Congestion Tone - Aastra 6730i Administrator's Manual

phone receives a call for any line other than the line that is being used to dial out. When the phone exits the ringing state
(e.g. the incoming call is answered), the tone device of the phone will revert back to originally configured audio device.
Feature compatibility is dependant on the IP phone model (see the following table for compability details).
IP Phone
9143i
9480i and 9480i CT
6730i
6731i
6735i
6737i
6739i
6753i
6755i
6757i and 6757i CT
6863i
6865i
6867i
Notes:
• The "ring audibly enable" parameter is disabled by default.
• This feature is not supported when utilizing the headset audio mode.
• With this feature enabled and when the phone's speaker is playing the incoming call's ring tone, call-waiting tones
will not be played.
Configuring the Ring Tone via Speaker During Active Calls Feature
Use the following procedures to configure the ring tone via speaker during active calls feature.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
page A-122.

No Service Congestion Tone

Administrators can configure the IP phones to play a congestion/fast busy tone instead of a dial tone when the phone is in
a "No Service" state. This feature allows visually impaired persons the ability to discern whether or not the phone is in serv-
ice and can be used to send/receive calls.
The configuration parameter "no service congestion tone" allows administrators the ability to enable this accessibility
feature. When enabled, the congestion tone will replace the conventional dial tone when the handset is off hook, a head-
set is employed, or the speakerphone is engaged. The congestion tone's frequency/pattern is based on the respective
phone's configured tone set. Additionally, the congestion tone is played on a per-line basis whereby only the specific lines
that are without service are affected.
Note:
If the phone or individual lines are configured to have no registration by intent (e.g. if the Registrar is set to 0.0.0.0) ena-
bling the "no service congestion tone" parameter will have no effect and the default dial tone will be played.
41-001343-02 REV05 – 07.2014
Handset Audio Mode
X

X
X









Operational Features
Speaker Audio Mode
X
X
X
X


X
X
X
X



"Ring Tone via Speaker During Active Calls Settings" on
5-94