6757I Cordless (Ct) Feature Keys - Aastra 6730i Administrator's Manual

Configuring the Increase of Displayed Characters for Softkey Line Labels
Use the following parameter to disable the line icon and increase the number of characters displayed for softkey line
:
labels
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
on page A-166.

6757i Cordless (CT) Feature Keys

In addition to the softkeys on the 6757i CT, this phone also has handset keys you can configure with specific features. You
can use the Aastra Web UI to configure the handset keys.
Note:
You configure the handset keys using the Aastra Web UI (Operation->Handset Keys) or by pressing the "F" button on
the handset.
You can program up to 15 feature keys on the 6757i CT handset with specific functions using the Aastra Web UI.
The following table identifies the functions available for all 15 handset keys and the default functions for each key.
Handset Key Key Function
1 Line 1
2 Line 2
3 Line 3
4 Line 4
5 Icom
6 Dir
7 Callers
8 Xfer
9 Conf
10 Public
11 None
12 None
13 None
14 None
15 None
Feature Key Programming Guidelines
The following are guidelines to use when programming the feature keys on the handset:
• All handsets paired with the same Base Station have the same programmed functions since the web interface applies
the functions to all the handsets paired with that base.
• A newly registered handset or handset that was out-of-range during the programming needs to perform an "off-hook
and on-hook" sequence in order for the newly programmed function to be broadcasted to the affected handsets. Sim-
ply press the v key from the idle state to go off-hook. Then, press the y key to go back on-hook.
• Duplicate functions can exist in the feature key as there is no filtering or duplicate checking done on the handset or the
41-001343-02 REV05 – 07.2014
Description
Line 1 key - Selects line one
Line 2 key - Selects line two
Line 3 key - Selects line three
Line 4 key - Selects line four
Icom key – Enter handset list to select handset to call
Directory key – Activate directory feature
Callers key – Activate callers feature
Transfer key - Activate transfer feature
Conference key - Activate conference feature
Public key – Toggle between public & private call mode
No function selected. Line 5 key (if available) - Selects line five.
No function selected. Line 6 key (if available) - Selects line six.
No function selected. Line 7 key (if available) - Selects line seven.
No function selected. Line 8 key (if available) - Selects line eight.
No function selected. Line 9 key (if available) - Selects line nine.
Operational Features
"Increase of Displayed Characters for Softkey Line Labels"
5-122