Audio Transmit And Receive Gain Adjustments - Aastra 6730i Administrator's Manual

Audio Transmit and Receive Gain Adjustments

The audio gain properties for the IP phone handset, headset, and speakerphone is adjusted to reduce side-tone and echo
on the local and far-end equipment. You can adjust these settings from -10 db to +10 db to best suit your comfort level
and deployment environment by using the following parameters in the configuration files:
• headset tx gain
• headset sidetone gain
• handset tx gain
• handset sidetone gain
• handsfree tx gain
• audio mode
The default setting for these parameters is 0 (zero).
Note:
Aastra recommends you leave the default of 0 (zero) as the settings for these parameters.
The following table describes each parameter.
Parameter
Headset tx gain
Headset sidetone gain
Handset tx gain
Handset sidetone gain
Handsfree tx gain
Audio mode
Configuring Audio Transmit and Receive Gain Adjustments
You can configure the audio transmit and gain adjustments using the configuration files only.
Use the following procedure to configure this feature.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
page A-149.
41-001343-02 REV05 – 07.2014
Description
The increased (+db) or decreased (-db) amount of signal transmitted from the headset microphone to the
far-end party.
The increased (+db) or decreased (-db) amount of sidetone signal from the headset microphone to the
headset speaker.
The increased (+db) or decreased (-db) amount of signal transmitted from the handset microphone to the
far-end party.
The increased (+db) or decreased (-db) amount of sidetone signal from the handset microphone to the
handset speaker.
The increased (+db) or decreased (-db) amount of signal transmitted from the base microphone to the far-
end party.
Allows you to configure how the d/f key (handsfree key) works. Audio mode has 4 options:
• 0 (Speaker) - Calls can be made or received using the handset or handsfree speakerphone and can be
switched between the two modes by pressing the d /fkey. When on speaker, you can return to using
the handset by placing the handset on the cradle and picking it up again.
• 1 (Headset) - Calls can be made or received using the headset. Calls can be switched between the head-
set and handset by pressing the d /fkey.
• 2 (Speaker/Headset) - Incoming calls are sent to the speakerphone. By pressing the d /fkey, you can
switch between the handsfree speakerphone, the headset, and the handset.
• 3 (Headset/Speaker) - Incoming calls are sent to the headset. By pressing the d /fkey, you can switch
between the headset, the handsfree speakerphone, and the handset.
Operational Features
"Audio Transmit and Receive Gain Adjustment Settings" on
5-38