Power Connector Cable - HP OMEN Maintenance And Service Manual

Power connector cable

Description
For use only on computer models equipped with the AMD R17M or Nvidia N17P GPUs
For use only on computer models equipped with the Nvidia N17E GPU
IMPORTANT:
and replacement
Before removing the power connector cable, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Hinge covers (see
b. System support brackets (see
Remove the power connector cable:
1. Disconnect the power connector cable from the system board (1).
2. Remove the power connector cable (2).
Reverse this procedure to install the power connector cable.
Make special note of each screw and screw lock size and location during removal
Battery on page
Hinge covers on page
33), and then remove the following components:
48).
System support brackets on page
Spare part number
926204-001
938137-001
49).
Component replacement procedures 51