Webcam - HP OMEN Maintenance And Service Manual

Webcam

NOTE: The webcam spare part kit includes does not include the webcam cable.
Description
For computer models equipped with an infrared webcam
For computer models equipped with a standard webcam
Webcam and display cable for use only on models equipped with an infrared webcam and ultra high
definition (UHD) panel
Webcam and display cable for use only on models equipped with an standard webcam and ultra high
definition (UHD) panel
Webcam and display cable for use only on models equipped with an infrared webcam and full high
definition (FHD) panel
Webcam and display cable for use only on models equipped with an standard webcam and full high
definition (FHD) panel
IMPORTANT:
and replacement
Before removing the webcam, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Hinge covers (see
b. System support brackets (see
c. Heat sink (see
d. System board (see
e. Display assembly (see
f. Display bezel (see
Remove the webcam:
1. Disconnect the webcam cable from the webcam board (1).
74 Chapter 6 Removal and replacement procedures for authorized service provider parts
Make special note of each screw and screw lock size and location during removal
Battery on page
Hinge covers on page
Heat sink on page
System board on page
Display assembly on page
Display bezel on page
33), and then remove the following components:
48).
System support brackets on page
56).
61).
65).
70).
Spare part number
919579-007
919573-009
929454-001
929453-001
929452-001
929451-001
49).