Cable Mounting Plate; Heat Sink Fan Assembly - Trane TR150 Service Manual

I-Frame Size Disassembly an...

8.2.2 Cable Mounting Plate

1. Remove the ribbon cable.
2. Remove 1 screw (T20) from shield metal.
3. Use a flat screwdriver to release the retainers and
connection terminals.
4. Use a hex 4 key to loosen the screws in the cable
connector.
5. Pull out the cables.
6. Slide the connector to the side and remove it.
7. Remove 2 screws (T20) from the mounting plate.
Reinstall in the reverse order.
8 8
1 EMC shield
2 Cable mounting plate
Illustration 8.2 Cable Mounting Plate
76

8.2.3 Heat Sink Fan Assembly

1.
2.
3.
4.
Reinstall in the reverse order.
1 Fan cover
2 Fan assembly
Illustration 8.3 Heat Sink Fan Assembly
02/2017 All rights reserved.
Unplug cable from power card.
Remove 2 screws (T20) from the fan mounting
plate.
Push the cable downwards. Use a screwdriver to
press the gasket down through the entry.
Pull out fan assembly.
BAS-SVM04B-EN