Some Held Jobs Were Not Restored; Supply Needed To Complete Job - Lexmark M5163dn User Manual

Troubleshooting
Serial port [x] disabled [56]
Try one or more of the following:
•
From the printer control panel, select Continue to clear the message.
The printer discards any data received through the specified serial port.
•
Select Reset active bin to reset the active bin for a linked set of bins.
•
Make sure the Serial Buffer menu is set to Enabled.

Some held jobs were not restored

From the printer control panel, select Continue to clear the message and continue printing.
Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
•
From the printer control panel, press
•
Unplug the router, wait for 30 seconds, and then plug it back again.
•
Turn off the printer, and then turn it back on.
•
Update the network firmware in the printer or the print server. For more information, visit the Lexmark
support Web site at http://support.lexmark.com.
Standard USB port disabled [56]
Try one or more of the following:
•
From the printer control panel, press
Note: The printer discards any data received through the USB port.
•
From the printer control panel, set USB Buffer to Auto.

Supply needed to complete job

Try one or more of the following:
•
From the printer control panel, select Prompt for supplies to view all error messages that indicate what
supplies are needed to continue processing the current job, and then press
and continue printing.
1
Order the missing supply immediately.
2
Install the supply. For more information, see the instruction sheet that came with the supply.
•
Cancel the print job, then install the missing supply, and then resend the print job.
to confirm.
to clear the message and continue printing.
189
to clear the message