Restore Held Jobs - Lexmark M5163dn User Manual

Troubleshooting
32.34
32.37
For more information, see
Note: If you do not have a replacement cartridge, then see the "Ordering supplies" section or go to
www.lexmark.com.
Replace unsupported imaging unit [32.xy]
Remove the imaging unit, and then install a supported one to clear the message and continue printing. For
more information, see the instruction sheet that came with the supply.
This error can also be caused by installing a genuine Lexmark imaging unit, such as a MICR unit, that is not
intended to be used in this product.
The following error codes indicate that a non‑genuine Lexmark imaging unit is installed:
32.14
32.17
32.20
32.23
32.26
32.29
32.32
32.35
32.38
For more information, see
Note: If you do not have a replacement imaging unit, then see the "Ordering supplies" section or go to
www.lexmark.com.
Replace wiper
1
Replace the fuser wiper. For more information, see the instruction sheet that came with the part.
2
Press to clear the message and continue printing.

Restore held jobs?

Do either of the following:
•
Select Restore on the printer control panel to restore all held jobs stored in the printer hard disk.
•
Select Do not restore if you do not want any print jobs to be restored.
"Using genuine Lexmark parts and supplies" on page
"Using genuine Lexmark parts and supplies" on page
140.
140.
188