Disk Must Be Formatted For Use In This Device - Lexmark M5163dn User Manual

Troubleshooting
Complex page, some data may not have printed [39]
Try one or more of the following:
•
From the printer control panel, press
•
Reduce the number and size of fonts, the number and complexity of images, and the number of pages
in the print job.
•
Cancel the print job.
•
Install additional printer memory.
Configuration change, some held jobs were not restored [57]
Held jobs are unavailable because of any of the following possible changes in the printer:
•
The printer firmware has been updated.
•
The tray for the print job is removed.
•
The print job is sent from a flash drive that is no longer attached to the USB port.
•
The printer hard disk contains print jobs that were stored when the hard disk was installed in a different
printer model.
From the printer control panel, press
Defective flash detected [51]
Try one or more of the following:
•
Replace the defective flash memory card.
•
From the printer control panel, press
•
Cancel the current print job.
Disk full [62]
Try one or more of the following:
•
From the printer control panel, press
•
Delete fonts, macros, and other data stored in the printer hard disk.
•
Install a printer hard disk with larger capacity.

Disk must be formatted for use in this device

From the printer control panel, select Format disk to format the printer hard disk and clear the message.
Note: Formatting deletes all the files stored in the printer hard disk.
to clear the message and continue printing.
to clear the message and continue printing.
to ignore the message and continue printing.
to clear the message and continue printing.
175