Bosch B6512 Installation Manual page 95

Control Panels
Figure 20.1: RESET button and Heartbeat LED location (B5512 shown)
Accessing SERVICE MODE (rapid pulsing Heartbeat LED):
1.
2.
Exiting SERVICE MODE and returning to normal operation (slow pulsing Heartbeat LED):
Press and hold the control panel RESET button for approximately 5 seconds until the
Heartbeat LED turns off. The control panel resets.
Conventions for this section
This guide to the keypad Installer menu provides instructions for using the keypad, based on
the following conventions:
–
–
–
–
Keypad menu trees
This section includes menu trees for the Installer menu structure, and the structures of the
B93x/B94x and B91x/B92x keypads user menus, for reference.
Bosch Security Systems, Inc.
Press and hold the control panel RESET button until the Heartbeat LED flashes fast. The
keypad shows SERVICE MODE and prompts for the installer passcode.
Enter your installer passcode and press ENTER.
All instructions access the Installer menu from the Main Menu (Installer) option, not
while in SERVICE MODE.
This section covers all compatible keypads. It provides specific steps for each keypad
style, when applicable.
For simplicity, the keypad Installer menu tree and instructions combine the two-line
keypad number selections with the text and graphic steps of other keypads. For example,
rather than indicating that the two-line keypad reads Press [2] for enhanced comm
parameters, and that a different keypad reads Enhanced Comm Parms, this section
indicates the selection as [2] Enhanced Comm Parms.
Go to [1] Programming Menu > [1] Reporting > [2] Network > [2] Enhanced Comm
Parms.
100BASE-T
LINK
ON-BOARD POINTS
Voltage Ranges
Open 3.7 - 5.0 VDC
Normal 2.0 - 3.0 VDC
Short 0.0 - 1.3 VDC
1 k End of Line Resistors
3 COM 4 5 COM 6
3 COM 4 5 COM 6
Installation Manual
Keypad Installer menu | en
ETHERNET
USB
C
OUTPUT
B
7 COM 8
7 COM 8
2017.04 | 15 | F.01U.287.180
95