Mitsubishi A1SJH(S8) User Manual page 162

11. TROUBLESHOOTING
Error
Error Message Code
(D9008)
"CAN'T 13
EXECUTE(P)"
(Checked at
instruction
execution.)
"CHK FORMAT 14
ERR"
(Checked at
STOP/PAUSE
RUN.)
"CAN'T 15
EXECUTE (I)"
(Checked at
interrupt
occurrence.)
Table 11.1 AnSHCPU Error Code List (Continue)
Detailed
CPU
Error
module
Code
status
(D9092)
— Stop (1) There is no jump destination or mul-
tiple destinations specified by the
CJ
instruction.
(2) Although there is no
tion, the
the program and has been exe-
cuted.
(3) The
JMP
with its jump destination located
below the
(4) The number of the
is different from that of the
instructions.
(5) A
FOR to NEXT
cessing to exit the loop.
(6) Processing exited subroutine by the
JMP
the
(7) Processing jumped into a step in a
FOR to NEXT
tine by the
— Stop (1) Instructions (including
LD X , LDI X , AND X
X
tion ladder block.
(2) Multiple
(3) The number of contact points in the
CHK
exceeds 150.
(4) The device number of X in the CHK
instruction circuit block exceeds
X7FE.
(5) There is no
before the
block.
(6) The device number of D1 of the
CHK D1D2
from that of the contact point before
the
(7) Pointer P254 is not given to the
head of the
block.
P254
— Stop (1) Although the interrupt module is
used, there is no number of interrupt
pointer I, which corresponds to that
module, in the program or there are
multiple numbers.
(2) No
entered in the interrupt program.
(3) There is
than the interrupt program.
Error and Cause
, , , , or
SCJ CALL CALLP JMP
instruc-
CALL
instruction exists in
RET
, , , , or
CJ SCJ CALL CALLP
instruction has been executed
instruction.
END
instructions
FOR
NEXT
instruction is given within a
JMP
loop causing the pro-
instruction before execution of
instruction.
RET
loop or into a subrou-
instruction.
JMP
) except
NOP
and ANI
are included in the instruc-
CHK
instructions are given.
CHK
instruction ladder block
ladder block
CJ P
instruction ladder
CHK
instruction is different
instruction.
CJ P
instruction circuit
CHK
CHK D1D2
instruction has been
IRET
instruction in other
IRET
11 - 13
Corrective Action
(1) Read the error step by use of the
peripheral device and correct the
program at that step.
(Insert a jump destination or reduce
multiple destinations to one.)
(1) Check the program in the
instruction ladder block according to
item (1) to (7) in the left column.
Correct problem using the peripheral
device and perform operation again.
(2) This error code is only effective
when the input/output control
method is a direct method.
(1) Check for the presence of interrupt
program which corresponds to the
interrupt unit, create the interrupt
program, and reduce the same num-
bers of I.
(2) Check if there is instruction in
IRET
the interrupt program and enter the
instruction.
IRET
(3) Check if there is instruction in
IRET
other than the interrupt program and
delete the instruction.
IRET
CHK