Fil- 1.0.8 Olc Activated? - Fresenius Medical Care 2008K2 Troubleshooting Manual

Yes Cables were OKAY! See procedure number
No Problem with a cable! After the repair, perform parts a THROUGH d below:
a) Turn the machine OFF then allow even (7) minutes BEFORE continuing to part b.
b) Return to Dialysis Program ("Select Program" → 'Dialysis' → 'CONFIRM')!
c) Allow Conductivity to increase to more than 13.0 mS.
d) Call debug screen 1.Watch FILACT for two (2) minutes. If REMAINING = 0 the problem
is solved. If still going ever = 1 return to (ABOVE) procedure number
413).

FIL- 1.0.8 OLC ACTIVATED?

From debug screen 0, once again, does the OLC POST Dialyzer Cond symbol appear?
Yes POST Dialyzer Cond symbol appears! A problem with Post Dialyzer Cond. Close the shunt
door THEN proceed to
No The OLC option will have to be activated as a bad OLC reading may cause Filling Programs EVEN
IF the OLC option is not activated! Perform parts a THROUGH i below:
a) Enter Service Mode → Options → Hardware Options.
b) Next to OLC (upper right) place the 'X' in the "Yes" box and press
'CONFIRM'. The 'X' turns blue.
c) Turn the machine off then back on.
d) Return to Dialysis Program ("Select Program"→ 'Dialysis' → 'CONFIRM')!
e) Call debug screen 0 and confirm the Post Dialyzer OLC symbols now appear.
The shunt door MUST be open!
f)
g) From the Home screen, ENSURING [Dialysate Flow] is set at 800 ml/min, allow Conductivity
to reach between 13.0 and 14.5 mS!
IMPORTANT!
h)
i) Call debug screen 0. Are PRE AND POST Cond within 0.4 of each other now?
Yes
No PRE AND POST Conductivity ARE NOT within 0.4 mS of each other! A problem with
Post Dialyzer Cond. Close the shunt door and proceed to
number
page 379
, p
Allow two (2) additional minutes for Post Conductivity to stabilize!
PRE AND POST Conductivity within 0.4 mS of each other! See procedure
number FIL- 2.0.0 (page 416).
CO- 10.0.10 (page 379).
2008K/K2 Troubleshooting Guide
P/N 507298 Rev. H
FIL- 1.0.8 (page 415).
CO- 10.0.10
rocedure number
FIL- 1.0.3 (page
.
page 379
, p
rocedure
Page 415