Siemens SIMATIC ET 200SP Manual page 50

Technical specifications
Note
When the encoder supply U
must be observed:
Horizontal mounting position:
Up to 70°C for up to 12 channels when using the digital outputs / encoder supplies (total current
of outputs 300 mA)
Up to 70°C for 16 channels without using the digital outputs / encoder supplies
Up to 65°C for 16 channels when using the digital outputs / encoder supplies (total current of
outputs 400 mA)
Up to 60°C for 16 channels when using the digital outputs / encoder supplies (total current of
outputs 2 A)
Vertical mounting position:
Up to 60°C for up to 12 channels when using the digital outputs / encoder supplies (total current
of outputs 300 mA)
Up to 60°C for 16 channels without using the digital outputs / encoder supplies
Up to 55°C for 16 channels when using the digital outputs / encoder supplies (total current of
outputs 400 mA)
Up to 50°C for 16 channels when using the digital outputs / encoder supplies (total current of
outputs 2 A)
Maximum supply voltage ripple during HART operation
● 390 mVpp at 50 Hz
● 8.3 mVpp at 300 Hz
Cycle time
The cycle time describes the period of time in which the signals from the inputs are acquired
and processed, and the outputs controlled.
The cycle time depends on the parameter assignment and may differ for each channel.
Mixed mode
Digital inputs for additional use of 8 HART variables
Digital inputs without additional use of 8 HART variables
Analog inputs with 60 Hz interference frequency suppression 16.6 ms
Analog inputs with 50 Hz interference frequency suppression 20 ms
Analog inputs with 10 Hz interference frequency suppression 100 ms
50
from the module (terminal 17...32) is used, the following derating
Vn
Input/output module AI-DI 16/DQ16x24VDC HART HA (6DL1133-6EW00-0PH1)
Cycle time
8 ms
4 ms
Manual, 05/2017, A5E39294170-AA