IBM BladeCenter JS12 Problem Determination And Service Manual page 196

Table 26. ssss-102 through ssss-640 SRNs (continued)
SRN FFC
ssss-122 ssss
ssss-124 ssss
ssss-126 ssss 252B
ssss-128 252B ssss
software
ssss-129 252B ssss
software
ssss-130 ssss
ssss-132 ssss
182
JS12 Type 7998: Problem Determination and Service Guide
Description and action
A SCSI reservation conflict error.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly" on page 274.
A SCSI check condition error occurred.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly" on page 274.
A software error was caused by a hardware failure.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly" on page 274.
The error log analysis indicates a hardware failure.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly" on page 274.
Error log analysis indicates a SCSI bus problem.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly" on page 274.
Error log analysis indicates a problem reported by the disk drive's self-monitoring
function.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly" on page 274.
A disk drive hardware error occurred.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly" on page 274.