Table of Contents
Advertisement
8. Verify that both of the connector retaining clips are in the fully open position.
9. Turn the DIMM so that the DIMM keys align correctly with the connector on
the system board.
Attention: To avoid breaking the DIMM retaining clips or damaging the
DIMM connectors, handle the clips gently.
10. Insert the DIMM by pressing the DIMM along the guides into the connector.
Verify that each retaining clip snaps into the closed position.
Important: If there is a gap between the DIMM and the retaining clips, the
DIMM is not correctly installed. Open the retaining clips to remove and
reinsert the DIMM.
11. Install and close the blade server cover. See "Installing and closing the blade
server cover" on page 245.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade server cover before installing the
blade server.
12. Install the blade server into the BladeCenter unit. See "Installing the blade
server in a BladeCenter unit" on page 242.
Removing the management card
Remove the management card to replace the card or to reuse the card in a new
system board and chassis assembly.
Figure 16. Removing the management card
Perform the following procedure to remove the management card.
Management
card
Retaining clip
Chapter 4. Removing and replacing blade server components
253
Advertisement
Table of Contents
