Table of Contents
Advertisement
Table 14. BA000010 to BA400002 Partition firmware SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, "Parts listing, Type 7998," on page 235 to determine which components are CRUs and which
components are FRUs.
Error code
BA210101
BA210102
BA210103
Description
The partition firmware event log queue
is full
There was a communication failure
between partition firmware and the
hypervisor. The lpevent that was
expected from the hypervisor was not
received.
There was a communication failure
between partition firmware and the
hypervisor. There was a failing return
code with the lpevent acknowledgement
from the hypervisor.
Action
1. Reboot the blade server.
2. If the problem persists:
a. Go to "Checkout procedure" on page
186.
b. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis
assembly" on page 274.
1. Review the event log for errors that
occurred around the time of this error.
2. Correct any errors that are found and
reboot the blade server.
3. If the problem persists:
a. Reboot the blade server.
b. If the problem persists:
1) Go to "Checkout procedure" on
page 186.
2) Replace the system-board and
chassis assembly, as described in
"Replacing the Tier 2 system-board
and chassis assembly" on page 274.
1. Review the event log for errors that
occurred around the time of this error.
2. Correct any errors that are found and
reboot the blade server.
3. If the problem persists:
a. Reboot the blade server.
b. If the problem persists:
1) Go to "Checkout procedure" on
page 186.
2) Replace the system-board and
chassis assembly, as described in
"Replacing the Tier 2 system-board
and chassis assembly" on page 274.
Chapter 2. Diagnostics
81
Advertisement
Table of Contents
