Table of Contents
Advertisement
Figure 20. Installing a small-form-factor expansion card
To install a small-form-factor expansion card, complete the following steps:
1. Read "Safety" on page v and the "Installation guidelines" on page 239.
2. Shut down the operating system, turn off the blade server, and remove the
3. Open and remove the blade server cover. See "Removing the blade server
4. Touch the static-protective package that contains the part to any unpainted metal
5. Orient the expansion card over the system board.
6. Slide the notch in the narrow end of the card into the raised hook on the
7. Install and close the blade server cover. See "Installing and closing the blade
8. Install the blade server into the BladeCenter unit. See "Installing the blade
262
JS12 Type 7998: Problem Determination and Service Guide
Expansion card
blade server from the BladeCenter unit. See "Removing the blade server from a
BladeCenter unit" on page 241.
cover" on page 244.
surface on the BladeCenter unit or any unpainted metal surface on any other
grounded rack component; then, remove the part from its package.
system board; then, gently pivot the card into the expansion card connectors.
server cover" on page 245.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade
server.
server in a BladeCenter unit" on page 242.
Advertisement
Table of Contents
