TP-Link Archer C2600 User Manual page 89

Check to see if you can log on to the web management page of the router. If you can, try the following steps. If
2)
you cannot, please set your computer referring to T3 and then try to see if you can access the Internet. If the
problem persists, please go to the next step.
Consult your ISP and make sure all the VPI/VCI, Connection Type, account username and password are correct. If
3)
there are any mistakes, please correct the settings and try again.
If you still cannot access the Internet, please restore your router to its factory default settings and reconfigure
4)
your router by following the instructions in
Please contact our Technical Support if the problem still exists.
5)
Note: For more details about Troubleshooting and Technical Support contact information, please log on to our Technical
Support Website: http://www.tp-link.com/en/support
T5. How to configure MAC Clone?
You can manually change the MAC address of the router. It is helpful when your Internet access account provided by
your ISP is bound to one specific MAC address, in other words, your ISP just permits only one computer with the
authenticated MAC address to access the Internet. In this case, you can use MAC Clone to allow more computers to
access the Internet via the same account.
1. Visit http://tplinkmodem.net, and log in with password you set for the router.
Advanced > Network
2. Go to
If you are using the computer with the authenticated MAC address to access the router, please select

Current Computer MAC
If you know the authenticated MAC address, please select

address.
3. Click OK to make the settings effective.
T6. How to change the operation mode?
The router support two operation modes, DSL Router Mode and Wireless Router mode. If you already have a modem
or your Internet comes via an Ethernet cable from the wall, you can set up the router as a regular wireless router to
share the Internet.
1. Connect your router's LAN4/WAN port to the modem or the network port.
2. Visit http://tplinkmodem.net, and log in with password you set for the router.
Advanced
3. Go to >
Internet
> page. Click the
Address.
Operation Mode
page.
Appendix B:
icon, and scroll down to get the MAC Clone tab.
Use Custom MAC Address
Troubleshooting Guide &
and then enter the
FAQ79
Use