Specify Dhcp Server Settings - TP-Link Archer C2600 User Manual

Specify DHCP Server Settings

11.3
By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and the router acts as a DHCP server; it
dynamically assigns TCP/IP parameters to client devices from the IP Address Pool. You can change the settings of
DHCP Server if necessary, and you can reserve LAN IP address for specified client device.
Visit http://tplinkwifi.net, and log in with the username and password you set for the router, and go to Advanced >
Network > DHCP Server page.
To use the router as an AP:
If you use another device on your network as the DHCP server, and the router act as an AP, you can disable the DHCP
feature in the router.
1. Clear the Enable DHCP Server check box.
2. Click Save.
To specify the IP address that the router assigns:
3. Make sure that the Enable DHCP Server check box is selected.
4. Type in the starting and ending IP address in the IP Address Pool.
5. Type in other parameters if the ISP offers, the Default Gateway is automatically filled the same as the LAN IP
address of the router.
6. Click Save.
Chapter 11 Specify the Network Settings54