TP-Link Archer C2600 User Manual page 68

Destination Network: is the destination IP address that you want to assign to a
static route. This IP address cannot be on the same subnet with the WAN IP or
LAN IP of the router. In the example, the IP address of the company network is
the destination IP address, so here enters 172.30.30.1.
Subnet Mask: determines the destination network with the destination IP
address. If the destination is a single IP address, enter 255.255.255.255;
otherwise, enter the subnet mask of the corresponding network IP. In the
example, the destination network is a single IP, so here enters 255.255.255.255.
Default Gateway: is the IP address of the gateway device to which the data
packets will be sent. This IP address must be on the same subnet with the
router's IP which sends out the data. In the example, the data packets will be
sent to the LAN port of Router 2 and then to the Server, so the default gateway
should be 192.168.0.2.
Interface: is determined by the port (WAN/LAN) that sends out the data packets.
In the example, the data is sent to the gateway through the LAN port, so LAN
should be selected.
Description: (Optional) Enter a description for this static routing entry.
4. Click OK to save the settings.
5. Check the System Routing Table below. If you can find the entry you set in
the System Routing Table, the static routing is set successfully.
Chapter 11 Specify the Network Settings58