TP-Link Archer C2600 User Manual page 20

Ac2600 wireless dual band gigabit router

Hide thumbs Also See for Archer C2600:

Table of Contents

Install the antennas and position them vertically for best signal reception.

Turn off the modem, and remove the backup battery if it has one.

Connect the modem to the Internet port on your router with an Ethernet cable.

Turn on the modem, and then wait about 2 minutes for it to restart.

Turn on the router.

Verify that the following LEDs are on and solid before continuing with the configuration.

Note:

If the 2.4G LED

check the LEDs again in a few seconds later.

Connect your computer to the router.

Option 1: Wired

Turn off the Wi-Fi on your computer and connect the devices as shown below.

and 5G LED

are off, please press the Wi-Fi On/Off button on the side panel for 2 seconds and

Chapter 2

Connect

Table of Contents