TP-Link Archer C2600 User Manual page 62

Change LAN Settings
11.1
11.1.1 Change the LAN IP address
The router is preset with a default LAN IP 192.168.0.1, which you can use to log in to its web-based management page.
The LAN IP address together with the Subnet Mask also defines the subnet that the connected devices are on. If the IP
address conflicts with another device on your local network or your network requires a specific IP subnet, you can
change it.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the router.
2. Go to Advanced > Network > LAN page.
3. Type in a new IP Address appropriate to your needs.
4. Leave the Subnet Mask as the default settings.
5. Click Save.
Note:
If the new LAN IP address is not in the same subnet with the old one, the IP Address Pool in the DHCP Server will
be automatically configured. However, the Virtual Server and DMZ Host will not take effect until they are
reconfigured.
In Addition:
Subnet Mask is an address code that determines the size of the network. Normally we use 255.255.255.0 as the subnet
mask.
Configure to support IPTV service
11.2
I want to
configure IPTV setup to enable Internet/IPTV/Phone service provided by my ISP (Internet service provider).
How can I do that?
Visit http://tplinkwifi.net, and log in with the username and password you set for the router. Go to Advanced >
Network > IPTV page.
If your ISP provide the networking service based on IGMP technology, e.g., BT (British Telecom) and Talk Talk in UK:
Tip: IGMP Proxy is to act as a multicast proxy for hosts on the LAN side.
1. Select the IGMP Proxy check box and choose the highest IGMP Version the system supports: V2 or V3.
2. Click Save.
Chapter 11 Specify the Network Settings52