Table of Contents
Advertisement
Installing/Removing
Arbor
Usually, once the chuck and arbor have been
properly mounted together, they are considered
semi-permanent connections. If you would like to
install a different chuck, we recommend getting a
new arbor for that chuck.
Installing Arbor in Spindle
Items Needed
Phillips Head Screwdriver #2 ............................ 1
Open-End Wrench 7mm .................................... 1
Acetone or Lacquer Thinner .............. As Needed
Rubber Mallet .................................................... 1
To install arbor in spindle:
DISCONNECT MACHINE FROM POWER!
1.
Loosen screw and hex nut shown in Figure
2.
25 to slide chuck guard off of quill and
remove.
Chuck Guard
Figure 25. Location of chuck guard fasteners.
Join chuck and arbor (refer to Joining Drill
3.
Chuck & Arbor on Page 21).
Rotate chuck on arbor until chuck jaws retract
4.
into drill chuck body.
Model T33901/T33902 (Mfd. Since 07/23)
Use acetone or lacquer thinner to clean mat-
5.
ing surfaces of arbor and spindle socket.
Slide arbor into spindle socket while slowly
6.
rotating chuck to line up tang on arbor with
slot in socket (see Figure 26).
Qty
Figure 26. Example of arbor tang aligned with
Strike face of chuck from below with rubber-
7.
faced mallet to seat arbor in spindle.
Check seat by gently pulling down on chuck.
8.
Install chuck guard, then tighten screw and
9.
hex nut from Step 2 to secure.
Tip: Use table to hold guard in place while
you tighten fasteners.
Scan this code to see a video of this installa-
tion process!
Spindle Socket
Arbor Tang
spindle socket.
-25-
Advertisement
Table of Contents
