Shift Pedal Adjustment - Yamaha XVS6501997 Service Manual

AIR BLEEDING (HYDRAULIC BRAKE SYSTEM)/

SHIFT PEDAL ADJUSTMENT

g. Loosen the bleed screw and allow the lever
to travel towards its limit.
h. Tighten the bleed screw when the lever limit
has been reached, then release the lever.
i. Repeat steps (e) to (h) until all the air
bubbles have disappeared from the brake
fluid.
NOTE:
When bleeding the brake system, make sure
that there is always enough brake fluid in the
brake fluid reservoir, before applying the brake
lever. Ignoring this precaution could allow air to
enter the brake system, lengthening the bleed-
ing procedure, considerably.
j. Tighten the bleed screw.
NOTE:
If bleeding is difficult, it may be necessary to let
the brake fluid settle for a few hours. Repeat the
bleeding procedure when the tiny bubbles in the
brake system have disappeared.
k. Fill the brake fluid reservoir to the proper
level.
Refer to "BRAKE FLUID LEVEL INSPEC-
TION".
After bleeding the brake system check the
brake operation.
**************************************************
EB304080
SHIFT PEDAL ADJUSTMENT
1. Check:
S Shift pedal position
Check the shift pedal rod length a .
If the position is incorrect ! Adjust.
3-27
INSP
ADJ
Bleed screw:
6 Nm (0.6 mSkg)
Shift pedal rod length:
188 mm