Gear Backlash Adjustment - Yamaha XVS6501997 Service Manual

MIDDLE GEAR
A = 44.03 – 43.45
= 0.58
6) Round off hundredths digit and select
appropriate shim(s).
In the example above, the calculated
shim thickness is 0.58 mm. The chart
instructs you, however, to round off 8 to
10.
Hundredths
0, 1, 2, 3, 4
5, 6, 7, 8, 9
Shims are supplied in the following thickness.
Middle drive pinion gear shim
Thickness (mm)
*****************************************************

GEAR BACKLASH ADJUSTMENT

1. Install:
S Middle gear backlash tool 1
NOTE:
This tool will prevent the drive axle from turning.
Middle gear backlash tool:
90890-04080
2. Install:
S Bolts (driven gear bearing housing)
NOTE:
D Just finger tighten the bolts at this stage.
D Clearance between the crankcase and the
driven bearing housing should be about 2
mm.
D Measure the gap with a feeler gauge 2 .
4-79
ENG
Round value
0
10
0.20 0.40
0.30