Crankshaft Installation - Yamaha XVS6501997 Service Manual

CRANKSHAFT AND CONNECTING RODS

CRANKSHAFT INSTALLATION

1. Attach:
S Main journal bearings 1
NOTE:
D Attach the main journal bearing to the plane
bearing installer/remover 2 middle driven
shaft bearing driver 3 .
D Align the projection a on the bearing with the
projection b and slot c on the special tools.
Plane bearing installer/remover:
90890-04074
Middle driven shaft bearing driver:
90890-04058
2. Install:
S Main journal bearings 1
NOTE:
Align the projection a on the bearing with the
slit b on the crankcase.
3. Install:
S Connecting rod bearings 1
NOTE:
D Align the projection a of the bearings with
the notches b in the connecting rod cap.
D Install each bearing in its original place.
4. Install:
S Connecting rods 1
NOTE:
D The stamped "Y" mark a on the connecting
rods should face towards the left side of the
crankcase.
D Install each connecting rod in its original
place.
4-62
ENG