Switch Rear Panel - Planet Networking & Communication LRP-822CS User Manual

■ 1000BASE-SX/LX SFP Interfaces (GE3 to GE4)
LED Color
LNK/ACT Green
1000 Orange

2.1.3 Switch Rear Panel

The rear panel of the LRP Managed Switch has an AC power socket, which accepts voltage from 100 to 240V AC at 50-60Hz.
Figure 2-1-3 shows the rear panel of these LRP Managed Switches.
Rear Panel
■ AC Power Receptacle
For compatibility with electric service in most areas of the world, the LRP Managed Switch's power supply automatically
adjusts to line power in the range of 100-240V AC at 50/60 Hz.
Plug the female end of the power cord firmly into the receptacle on the rear panel of the LRP Managed Switch. Plug the
other end of the power cord into an electrical outlet and the power will be ready.
The device is a power-required device, which means it will not work till it is powered. If your networks
should be active all the time, please consider using UPS (Uninterrupted Power Supply) for your device.
Power Notice:
It will prevent you from network data loss or network downtime.
In some areas, installing a surge suppression device may also help to protect your LRP Managed
Power Notice:
Switch from being damaged by unregulated surge or current to the LRP Managed Switch.
If LNK/ACT LED lights up, it indicates that the port is operating at 10/100Mbps.
Lights
If LNK/ACT LED is off, it indicates that the port is linkdown.
Off
To indicate the link through that port is successfully established.
Lights
Blinking To indicate that the switch is actively sending or receiving data over that port.
To indicate that the port is operating at 1000Mbps.
Lights
If LNK/ACT LED lights up, it indicates that the port is operating at 100Mbps.
Lights
If LNK/ACT LED is off, it indicates that the port is linkdown.
Off
Figure 2-1-3 Rear Panel of LRP-822CS/LRP-1622CS
User's Manual of LRP-822CS/LRP-1622CS
Function
27