Lag Port Setting - Planet Networking & Communication LRP-822CS User Manual

 Link State

Active Member
 Standby Member

Modify

4.4.3 LAG Port Setting

This page allows setting configuration for each LAG. The LAG Port Setting screens in
The page includes the following fields:
Object

LAG Select
 Enable
 Speed

Flow C ontrol
Display the link state
Display the active member
Display the standby member
Click to modify LAG configuration
e 4-4-6 LAG Port Setting Information Page Screenshot
Figur
Description
Select LAG number from this drop-down list.
Indicates the LAG state operation. Possible states are:
Enabled - Start up the LAG manually.
Disabled – Shut down the LAG manually.
Select any available link speed for the given switch port. Draw the menu bar to
select the mode.

Auto – Set up Auto negotiation.

Auto-10M – Set up 10M Auto negotiation.

Auto-100M – Set up 100M Auto negotiation.

Auto-1000M - Set up 1000M Auto negotiation.

Auto-10/100M – Set up 10/100M Auto negotiation.

10M – Set up 10M Force mode.

100M – Set up 100M Force mode.

1000M – Set up 1000M Force mode.
When Auto Speed is selected for a port, this section indicates the flow control
capability that is advertised to the link partner. When a fixed-speed setting is
selected, that is what is used.
frames on the port are ob
User's Manual of LRP-822CS/LRP-1622CS
Figure 4-4-6
The current RX column indicates whether pause
eyed. The current TX column indicates whether pause
106
& Figure 4-4-7 appear.