Table of Contents
Advertisement
2.1.3 Switch Rear Panel
The rear panel of the Managed Switch consists of the AC inlet power socket.
of the Managed Switches.
XGS-6320-8X8TR and XGS-6320-12X4TR Rear Panel
XGS-6320-8UP4X Rear Panel
■ AC Power Receptacle
For compatibility with electrical voltages in most areas of the world, the Managed Switch's power supply can automatically
adjust line power in the range of 100-240V AC and 50/60 Hz.
Plug the female end of the power cord firmly into the receptacle on the rear panel of the Managed Switch and the other end
of the power cord into an electrical outlet and the power will be ready.
The device is a power-required device, which means it will not work till it is powered. If your networks
should be active all the time, please consider using UPS (Uninterrupted Power Supply) for your device.
Power Notice:
It will prevent you from network data loss or network downtime. In some areas, installing a surge
suppression device may also help to protect your Managed Switch from being damaged by unregulated
surge or current to the Switch or the power adapter.
2.2 Installing the Switch
This section describes how to install your Managed Switch and make connections to the Managed Switch. Please read the
following topics and perform the procedures in the order being presented. To install your Managed Switch on a desktop or shelf,
simply complete the following steps.
In the installation steps below, this manual uses the XGS-6320-8X8TR as an example. However, the
steps for XGS-6320-12X4TR and XGS-6320-8UP4X are similar.
Figure 2-1-3-1: Rear Panel of XGS-6320-8X8TR / XGS-6320-12X4TR
Figure 2-1-3-2: Rear Panel of XGS-6320-8UP4X
User's Manual of XGS-6320 Managed Switches
Figures
2-1-3-1and
30
2-1-3-2
show the rear panels
Advertisement
Table of Contents
