Table of Contents
Advertisement
4.15.2 System Configuration
In a power over Ethernet system, operatin
infrastructure to powered devices (PDs),
by PDs can
exceed the ma
power than t
he total potential p
m
ajority of the ports, power management is implemented.
The PSU input power consumption is monitored by measuring v
system's aggregated power consumption .The power management concept allows all ports to be active a
ports, as long as the aggregated power of the system is l
connected .When this val
ue
m
anaged according to the following user-definable parameters: maximum available power, ports priority and maximum
allowable power pe
r port.
Reserved Power
There are five m
od
e
s for configu
Allocation mode
In this mode, the user allocates the amount of power that each port may reserve. The allocated/reserved power for each
port/PD is specified in the Maximum Power fields. The ports are shut down when total reserved power exceeds the amount
of power that the power supply can deliver.
In this mode, the port power is not turned on if the PD requests more available power.
4.15.3 Power over Ethernet Configuration
This section allows the user to inspect and configure the current PoE configuration setting
appears.
g power is applied from a power source (PSU-po
which are connected to ports. Under some conditions, the total output powe
ximum availabl
e power provided by the PSU. The system with a PSU is capable of supplying less
ower consu
mption of all the PoE ports in the system. In order to maintain the func
is exceeded, ports will be deactivated, according to user-defined priori
ring how the ports/PDs may reserve power and when to shut down ports.
Figure 4-16-1: PoE Configuration Screenshot
User's Manual of LRP-822CS/LRP-1622CS
oltage and current .The input power consumption is equal to the
ower than the power level at which additional PDs cannot be
332
wer supply unit) over the LAN
tion of the
nd activates additional
ties. The power budget is
as screen in
Figure 4-16-1
r required
Advertisement
Table of Contents
