Daikin G-Series Service Manual page 78

FTXS20/25/35/42/50G2V1B
To start 3-D Airflow
1. 3. Press the "SWING button
the "
will move in turn.
To cancel 3-D Airflow
2. 4. Press either the "SWING button
COMFORT AIRFLOW operation
• Check COMFORT AIRFLOW operation in the section of "COMFORT AIRFLOW Operation"
and "INTELLIGENT EYE Operation". (page 14.)
Notes on flaps and louvers angles
• When "SWING button" is selected, the flaps
swinging range depends on the operation
mode. (See the figure.)
Three-Dimensional (3-D) Airflow
• Using three-dimensional airflow circulates
cold air, which tends to collected at the bottom
of the room, and hot air, which tends to collect
near the ceiling, throughout the room,
preventing areas of cold and hot developing.
ATTENTION
• Always use a remote controller to adjust the
angles of the flaps and louvers. If you
attempt to move it forcibly with hand when it
is swinging, the mechanism may be broken.
• Always use a remote controller to adjust the
louvers angles. In side the air outlet, a fan is
rotating at a high speed.
67
" and " " display will light up and the flap and louvers
" and the "SWING button
" or the "SWING button
In DRY mode or
COOL mode
COMFORT AIRFLOW 5˚
(page 14.)
15˚
50˚
Upper limit
Lower limit
In HEAT mode
Stop operation
30˚
Upper limit
70˚
Lower limit
80˚
COMFORT AIRFLOW (page 14.)
In FAN mode
5˚
Upper limit
80˚
Lower limit
SiBE04-808_B
":
".
Stop operation
Stop operation
13
Operation Manual