Test The Key Switch; Test The Emergency Stop Buttons - Genie S-65 Service Manual

Service Manual - Second Edition
800-610-4101
ActionRental.com
4 Loosen the yoke lock nut, then turn the high idle
adjustment nut and solenoid boot
counterclockwise to increase the rpm or
clockwise to decrease the rpm. Tighten the
yoke lock nut and recheck the rpm.
Be sure the solenoid fully retracts
when activating high idle.
Deutz Diesel models
Low idle
High idle
B-13

Test the Key Switch

Proper key switch action and response is essential
to safe machine operation. The machine can be
operated from the ground or platform controls and
the activation of one or the other is accomplished
with the key switch. Failure of the key switch to
activate the appropriate control panel could cause
a hazardous operating situation.
1 Pull out the Emergency Stop button to the
position at both the ground and platform
controls.
2 Turn the key switch to ground control, start the
engine and then turn the key switch to platform
control.
3 Check any machine function from the ground
controls.
Result: The machine functions should not
operate.
4 Turn the key switch to ground control.
5 Check any machine function from the platform
controls.
Result: The machine functions should not
operate.
Part No. 48412
Section 4 - Scheduled Maintenance Procedures
6 Turn the key switch to the
Result: The engine should stop and no
functions should operate.
1300 rpm
B-14
Test the Emergency
2300 rpm
Stop Buttons
Properly functioning Emergency Stop buttons
are essential for safe machine operation. An
improperly operating Emergency Stop button
will fail to shut off power and stop all machine
functions, resulting in a hazardous situation for
ground and platform personnel.
ON
1 Start the engine from the ground controls.
2 Push down the Emergency Stop button to the
position.
OFF
Result: The engine should shut off and no
machine functions should operate.
3 Start the engine from the platform controls.
4 Push down the Emergency Stop button to the
position.
OFF
Result: The engine should shut off and no
machine functions should operate.
Genie S-60 & Genie S-65
TABLE B PROCEDURES
position.
OFF
Deutz Diesel models: All functions
should stop immediately. The
engine will shut off after 2 to 3
seconds.
As a safety feature, selecting
and operating the ground controls
will override the platform controls,
including the Emergency Stop
button.
Deutz Diesel models: All
functions should stop immediately.
The engine will shut off after 2 to 3
seconds.
The ground Emergency Stop
button will stop all machine
operation, even if the key switch
is switched to platform control.
4 - 21