Error Or Warning Messages - Mitel 5614 User Manual

Mitel 5614 DECT Phone User Manual for MiVB
FAULT

ERROR OR WARNING MESSAGES

DISPLAY SHOWS
No access
No System. The handset
beeps once a minute
(during max 30 minutes)
with a low tone followed
by a high tone (if enabled,
the vibrator also follows
the beeps).
The message
displayed when the
handset tries to
download an ECG
waveform image.
116
PROBABLE CAUSE
2) The IP-DECT system is not
configured for Easy Registration.
3) There is ambient equipment
disturbing your IP-DECT system.
PROBABLE CAUSE
The network is in range, but no
access rights.
The handset is out of coverage or
handset is defective.
Failed
is The IP-DECT wireless connection
point is overloaded with too many
calls.
ACTION OR COMMENT
2) Subscribe the handset
Subscribe Handset
manually, see
in DECT System Manually
page 76,
or
configure the system to
support Easy Registration,
refer to the applicable Installation
and Operation Manual for
your IP-DECT system.
3) Try to subscribe the
handset in other area in your
building.
4) If the problem still exists,
restart your handset and
subscribe the handset.
ACTION OR COMMENT
Switch handset off and then
switch it on again or contact
system administrator.
Stop the beep with the Sound off
key and go into range.
Note: When re-entering the
coverage area it can take a
couple of minutes before the
handset automatically has
registered into the system.
or contact system administrator.
Go refer to the patient. The ECG
Monitoring functionality starts
working when the IP-DECT
connection point is no longer
overloaded.
on