Monitor Panel (Log Page) - HP StorageWorks Edge Switch 2/12 Service Manual

Table 15: Port Operational States (Continued)
Online
Beaconing
Invalid
Attachment
Link Incident
Link Reset
No Light
Edge Switch 2/12 Service Manual
Port Blue/Green
State LED
On or
Blinking
Off, On, or
Blinking
On
Off
Off
Off
Amber
LED
Off An attached device is connected to the
switch and ready to communicate, or
is communicating through the switch
with other attached devices.
If the port remains online at 1.0625
Gbps, the blue/green LED illuminates
green. If the port remains online at
2.125 Gbps, the blue/green LED
illuminates blue.
At the switch, the blue/green LED
blinks green when there is Fibre
Channel traffic through the port at
1.0625 Gbps. At the switch, the
blue/green LED blinks blue when there
is Fibre Channel traffic through the
port at 2.125 Gbps.
Blinking The port is beaconing. The amber port
LED blinks once every two seconds to
enable users to locate the port.
Off The port has an invalid attachment.
The reason appears in the Reason field
of the Port Properties page of the EWS
View panel.
Off A link incident occurred. The alert
information appears in the EWS event
log.
Off The switch and attached device are
performing a link reset operation to
recover the link connection. This is a
transient state that should not persist.
Off No signal (light) is received at the
switch port. This is a normal condition
when there is no cable attached to the
port or when the attached device is
powered off.
Repair Information
Description
93