Switcher Setup - Sony MVS-8000 User Manual

• Flexi Pad: Carry out Flexi Pad settings. Specify the delegation selection
coupling, and display mode for the LCD buttons.
• Custom Button: Set the following button operation modes.
– [ALL] button for next transition selection
– [AUTO TRANS], [TAKE] or [FTB] button during auto transition
execution
– [RUN] button during keyframe execution
– [AUTO TRANS] and [CUT] button replacement
– [TRANS PVW] button
– [UTIL] button
– [XPT HOLD] button in key rows
• Sensitivity: Adjust trackball, joystick and double-click sensitivity.
• Main Split Fader: When the split fader is active, specify whether the fader
to control other than mix is the left side or the right side.
• Macro: Set the macro execution mode and the mode in which to edit macros
using the standard type Flexi Pad control block.
Screen saver and other settings (Maintenance)
• Screen Saver: Make the menu screen saver settings.
• LCD Brightness: Adjust the LCD brightness.
• LED Brightness: Adjust the LED brightness.
• Switch Brightness: Adjust the switch brightness.
• Touch Beep: Select whether or not to sound a beep when a menu operation
is carried out.
• Touch Panel Calibration: Calibrate the touch panel.

Switcher Setup

In switcher setup, make settings particular to the switcher processor.
You can make the following settings.
Settings relating to overall switcher configuration (Config)
• System Phase: Adjust the switcher internal reference phase.
• Switch Timing: Specify the timing of video switching.
• M/E Config: Set the program configuration for the M/E and P/P outputs.
– Standard mode: Fix the maximum of four outputs (Out1 to 4) and
program output configuration as follows.
Out1: Program output
Out2: Preview output
Out3: Clean output
Out4: Key preview output
Program output: Clean output + key 1 + key 2 + key 3 + key 4
181
Setup