Key Snapshot Operations Using A Simple Transition Module - Sony MVS-8000 User Manual

Key Snapshot Operations Using a Simple Transition
Module
When using a simple transition module, the key snapshots hold the settings for
key 3 and key 4.
You can carry out key snapshot operations in the independent key transition
control block (simple type) and Flexi Pad control block (simple type).
There are two dedicated key snapshot registers for each of keys 3 and 4.
Key source name display/key
snapshot buttons
The functions of the key 3 control block and key 4 control block are the same.
Saving a key snapshot
For example, to save the settings of M/E-1 key 3, use the following procedure.
1
368
Key Snapshots
Key 3 control block Key 4 control block
K-SS button
Independent key transition control block (simple type)
In the M/E-1 independent key transition control block, press the [K-SS]
button in the key 3 control block, turning it on.
This switches to key snapshot mode, and the key source name display/key
snapshot button shows the state of registers 1 and 2 for key 3.
Off: Nothing is saved in the register.
Lit orange: Settings are saved in the register.
For a register holding a snapshot, the register name is shown as up to eight
characters.
K-SS WIPE DME K-SS
SHIFT MIX CUT SHIFT
KEY3
ON
TAKE
WIPE DME
MIX CUT
KEY4
ON
TAKE