Applying A Dme Effect To A Key - Sony MVS-8000 User Manual

Knob
1
2
• When utility 1 bus is selected
Knob
1
2

Applying a DME Effect to a Key

For one M/E bank, DME effects (including DME wipes) can be used in up to
two places on the dedicated interface and in only one place on the SDI interface
simultaneously.
Assigning a DME to a key
Use the following procedure.
1
2
Using two or three DME channels on one keyer
When using the DME dedicated interface, proceed as follows.
362
Key Setting Operations With the Key Control Block
Parameter Adjustment
Size Pattern size
Soft Edge softness
Parameter Adjustment
Clip Reference level for
creating mask signal
Gain Gain
In the key control block, press the delegation buttons [M/E1] and [KEY1].
Using the DME channel selection buttons, select the DME channel (DME1
to DME8) for applying the effect.
The lit colors of the [DME1] to [DME8] buttons indicate the DME
assignment.
Lit green: Shows the DME assigned to the currently selected key.
Lit amber: Shows the DME assigned to a key other than the currently
selected key.
Off: DME is not assigned.
To select a DME being used by another keyer
Press [Override], turning it on, then select the DME channel.
The later selection is valid, and the button lights green.
Setting values
0 to 100
0 to 100
Setting values
+109 to –7
–100 (shown as –00) to +100