Sony MVS-8000 User Manual page 225

to [KEY4]) corresponding to the key you
want to bring to the front.
i KF (keyframe) button
When the VTR/disk recorder operation
mode is enabled in setup, pressing this
button cues the tape automatically to the
start point.
The following controls are used as the
independent key transition control block.
j Key delegation buttons
These buttons delegate this independent
key transition control block to a desired
keyer. Press one of the [KEY1] to [KEY4]
buttons ([DSK1] to [DSK4] in the PGM/
PST bank), turning it on.
You can press more than one button to
select two or more keyers.
While these buttons are held down, you can
select a key source with the cross-point
buttons for the key bus.
Pressing one of these buttons twice in rapid
succession changes its state so that you can
make cross-point selections on the
corresponding key bus.
Key delegation button
(double press)
[KEY1]
[KEY2]
[KEY3]
[KEY4]
a) The key bus selection button [KEY3] in the cross-
point control block goes off.
b) The key bus selection button [KEY4] in the cross-
point control block goes off.
c) The key bus selection button [KEY3] in the cross-
point control block lights.
d) The key bus selection button [KEY4] in the cross-
point control block lights.
k Independent key transition type
Press one of the following buttons, turning
it on, to select the independent key
transition type.
MIX: Faded in or out.
WIPE: Inserted or deleted with a wipe.
DME (DME wipe): Inserted or deleted
l Independent key transition
KEY1 ON to KEY4 ON (DSK1 ON to
AUTO TRANS (transition) buttons:
Corresponding
key bus
m Key source name display/key
a)
key 1
These display the source name selected on
b)
key 2
the corresponding keyer. In key snapshot
c)
key 3
mode, press these buttons, corresponding to
d)
registers 1 to 4 for the selected keyer, to
key 4
save or recall a key snapshot.
n Key snapshot setting buttons
K-SS (key snapshot): This enables key
K-SS STORE (key snapshot store): To
Names and Functions of Parts of the Control Panel
selection buttons
with a DME wipe.
execution section
DSK4 ON in the PGM/PST bank)
buttons: Press the corresponding one
of these buttons to cut key 1 to key 4 in
or out instantaneously. When the key
corresponding to the button appears in
the final program output, the button
lights red, and otherwise lights amber.
These correspond to keys 1 to 4 from
left to right; press one to carry out an
auto transition. The transition rate for
an independent key transition can be
set in the numeric keypad control
block, in the Flexi Pad control block, or
in a menu.
snapshot buttons
snapshot mode.
save a key snapshot, hold down this
button, and press the key source name
display/key snapshot button
corresponding to the register you want
to save.
225