ShoreTel 930D Planning And Installation Manual page 67

5 Reference Material
Parameter
SetupPassword
SntpServer
SubNetMask
SysLogInfo
ShoreTel IP Phone 930D
Value Type Value
32 ASCII Characters This is the MD5 hash of the password that must be
entered after the Mute button is pushed to enter a
manual key command. Note that this password must be
saved in flash after a value has been received from the
MGC so it can be enforced on subsequent reboots. It is
not cleared by the CLEAR command nor the clear step
in the SETUP command.
Dotted Decimal ASCII SNTP server address in dotted decimal format.
Dotted Decimal ASCII Network Mask for the base. On boot, the base checks
for a non-zero NV value, and if one is present it is used.
Up to 32 ASCII IP Address, module, verbose level, facility code, and
Characters output device of the SysLog function. The port number
may be optionally identified and appended to the IP
address. The default of 514 will be used if no port is
specified.
The module is a 32-bit integer where each bit refers to
the debug enable/disable status from a specific software
module. Bit assignments are:
0: "MGCC"
1: "MCFGP"
2: "MUSTG"
3: "MNETC"
4: "MUI"
5: "MDIS"
6: "MPROV"
7: "MAINT"
8: "MRMON
9: "MFWU"
10: "MVPN"
11: "MM"
12: "MLCMD"
13: "MFACT"
14: "MISC"
15: "MEPT"
Understanding Configuration Parameters
#MGCP
#config file parser
#not used
#network configuration
#DECT man machine interface
#not used - display module
#provisioning
#maintenance
#not used
#DECT firmware upgrade
#not used
# DECT mobility management
#local mode
#DECT factory test
#DECT miscellaneous API
#not used
Planning and Installation Guide
Sources Default
MGCP, 1234
DHCP
DHCP, 0.0.0.0
CFG, MAN
DHCP, 0.0.0.0
MAN
CFG 0.0.0.0,0,0,0,0
67