ShoreTel 930D Planning And Installation Manual page 65

5 Reference Material
Parameter
Ethernet1
FtpServers
GatewayAddress
IcmpArpTimeout
Include
IPAddress
KeepAlive
Language
Layer2Audio
Layer2Tagging
Layer2Signaling
LldpEnable
MaxJitter
ShoreTel IP Phone 930D
Value Type Value
Up to 10 ASCII Status of the 1st Ethernet Interface.
Characters Ethernet1 Status, Speed/Duplex
Where:
Status is 0 or 1 (disabled or enabled)
Speed/Duplex is one of the following:
Auto
10/FD
10/HD
100/FD
100/HD
Up to 255 ASCII A comma separated list of up to 2 FTP servers. If a
Characters server is unavailable the base goes through the list until
a working server is found.
Dotted Decimal ASCII Gateway address for the base.
Up to 5 ASCII Number of minutes before routing table entries created
Characters by ICMP redirects are timed out of the routing table.
If 0, then they never time out.
Up to 64 ASCII The file name that is specified shall be read and its
Characters contents included into the master configuration file. Files
may be specified completely, or may include the
variables $Hardware, $Country or $Language. The
value of the Hardware Version (programmed into flash at
the factory e.g. K01M01P01L01), Country or Language
Parameter shall be substituted for $Hardware, $Country
or $Language when the file name is created. For
example:
Include "Country_$Country.txt" with the Country
parameter set to 3 would load in the file "Country_3.txt"
This will permit parameters to be specified based on the
Country and Language parameter values.
Dotted Decimal ASCII IP address to be used by the base.
Up to 3 ASCII Number of seconds to wait for an audit endpoint
Characters command before initiating the recovery procedures in
ShorelinePR.4.2.170. If set to zero recovery procedures
will never be started.
Valid range is 0 to 999 seconds.
Up to 3 ASCII This parameter specifies the Language that is used by
Characters the Include parameter to identify a particular file to
include. May be between 1 and 255.
1 ASCII character Layer 2 audio priority values from 0 to 7.
1 ASCII character 802.1Q tagging enable on Port 1
0=Disable
1=Enable
1 ASCII character Layer 2 signaling priority values from 0 to 7.
1 ASCII character LLDP enabled if 1 and disabled if 0.
Up to 4 ASCII The maximum value that the jitter buffer may be allowed
characters to grow. Valid values are 40 to 140 mS in 1 mS steps.
Understanding Configuration Parameters
Sources Default
CFG, MAN 1,Auto
DHCP, 0.0.0.0
MAN
DHCP, 0.0.0.0
MAN
CFG 0
CFG ""
DHCP, 0.0.0.0
MAN
CFG 120
SSON, 1
CFG, MAN
CFG, 5
LLDP
SSON, 0
CFG,
MAN,
LLDP
CFG, 0
LLDP
MAN 1
CFG 50
Planning and Installation Guide 65