Run/Stop Switch - APRILIA DORSODURO 1200 ABS - ATC Service Station Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
DORSODURO 1200 ABS - ATC
•
8. WITH THE SWITCH SET TO "RUN", WHAT DOES THE "RUN-STOP SWITCH" STATUS
ON THE DIAGNOSIS INSTRUMENT, DEVICES STATUS SCREEN PAGE, ICON 0/1
MEAN?
•
9. CHECK THROUGH THE DIAGNOSIS INSTRUMENT THE CORRECT OPERATION OF
THE SIDE STAND, THE NEUTRAL SENSOR, THE CLUTCH SENSOR: OPERATE ANY
DEVICE AND CHECK THE SUITABLE INDICATION ON THE DEVICE STATUS, ICON 0/1
SCREEN PAGE.
If there is a fault, go to 10; if everything works correctly, go to 11
•
10. ACCORDING TO THE FAULT, SEE CHAPTER "ELECTRICAL SYSTEM/CHECK AND
CONTROLS/NEUTRAL GEAR SENSOR" or "ELECTRICAL SYSTEM/CHECK AND CON-
TROLS/GEAR SENSOR" or "ELECTRICAL SYSTEM/CHECK AND CONTROLS/SIDE
STAND SENSOR" - END
•
11. REPLACE THE CONTROL UNIT - END
•
12. IS THE "FALL SENSOR" IN VERTICAL POSITION?
•
13. REFER TO THE CHAPTER "ELECTRICAL SYSTEM/CHECKS AND CONTROLS/FALL
SENSOR"; INDICATION ON DIAGNOSIS INSTRUMENT ALWAYS "TIP OVER" - END
•
14. SET THE SENSOR TO THE CORRECT POSITION - END
•
15. REFER TO THE CHAPTER "ELECTRICAL SYSTEM/CHECKS AND CONTROLS/RUN
- STOP SWITCH"; INDICATION ON DIAGNOSIS INSTRUMENT ALWAYS "STOP" - END
•
16. CHECK OPERATION OF FUEL CIRCUIT PRESSURE AND ENGINE MECHANICAL
OPERATION - END
See also
Engine rpm sensor
Neutral sensor
Side stand sensor

RUN/STOP switch

CHECK CONTROL UNIT POWER SUPPLY
•
1. WITH THE KEY TURNED TO "OFF" CHECK IF THERE IS BATTERY VOLTAGE AT PIN
52 OF THE CONTROL UNIT, CABLE HARNESS SIDE
•
2. WITH THE KEY TURNED TO "ON" THERE IS BATTERY VOLTAGE AT PIN 40 OF THE
CONTROL UNIT, CABLE HARNESS SIDE (IN CASE OF LACK OF POWER SUPPLY ON
email: info@motomatrix.co.uk
If NORMAL is shown, go to 8; if TIP OVER is shown, go to 12
If "RUN" is shown, go to 9; if "STOP" is shown, go to 15
YES, go to 13; NO, go to 14
YES, go to 2; NO, go to 5
Troubleshooting
TROUBL - 81