Battery - APRILIA DORSODURO 1200 ABS - ATC Service Station Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
DORSODURO 1200 ABS - ATC
•
The BUFRSVXX.BIN file is saved in the diagnosis instrument memory card or in your PC
hard disk, if you are using Piaggio Group Diagnostic Software combined to the diagnosis
instrument: data regarding the control unit serial number and the serial number of the diag-
nosis instrument that has carried out the download is also included in the file
Saved data file deletion
Error cause
•
Deletion enabled only if the file is downloaded after setting KEY ON
NEW CONTROL UNIT ACTIVATION PROCEDURE and REPROGRAMMING
After installing the control unit for the first time, or after REPROGRAMMING the control unit with a
different or more updated mapping, turn the key to ON and wait 3 seconds; during this time the control
unit carries out throttle position acquisition. Connect to diagnosis instrument and check that the statuses
"Front throttle automatic self-acquisition" and "Rear throttle automatic self-learning" are "Carried out"
and "Handle self-acquisition" is "Not carried out" (this last status entails Urgent service being displayed
on the instrument panel). If front and rear throttle automatic self-acquisition indicate "Not carried out"
go to phase 1, if indicate "Carried out" go to phase 2. Phase 1: current errors have probably been
detected by the control unit: solve these malfunctions and check the two statuses. Throttle Self-learning
can also be checked from the Parameter adjustment (screwdriver and hammer) screen page. Stage 2:
Carry out the Handle Self-learning from the Parameter adjustment (screwdriver and hammer) screen
page and check that Handle Self-learning status is Carried out. If not OK the voltage detected on the
throttle is out of scale (check with diagnosis instrument) or current errors have been probably detected
by the control unit: solve these malfunctions and repeat the procedure

Battery

Function
Battery YTX 14-BS, which must be activated and
loaded.
Level in electrical circuit diagram:
Battery recharge
Location:
•
on the vehicle: under the saddle
•
connector: on the battery
Electrical specifications: 12 Ah
Pin out:
1. Positive pole (red): approx. 12.6 V
2. negative pole (black): ground connection
DIAGNOSIS INSTRUMENT: PARAMETERS
email: info@motomatrix.co.uk
Electrical system
ELE SYS - 131